7978
CUSTOM FUNCTIONS
1 – DX Memory Off
Film speed is always set to the DX-coded ISO. Non-DX-coded film is
set to the ISO of the previous roll.
Cust 4 – DX Memory
2 – DX Memory On
Changes to the film speed for a DX coded roll are saved and applied
to future rolls with the same DX coded ISO. Use to consistently
over/under-expose a specific film type.
• Film must be loaded before the ISO can be changed.
1 – Autoswitchover
Built-in flash pops-up when shutter-release button is pressed partway
down. Flash will fire when necessary.
Cust 5 – Flash Control in P Mode
2 – Fill Flash (Manual Switchover)
Flash-mode button must be pressed to
raise the built-in flash (p27). Flash will fire
every time the shutter is released.
• The TTL exposure system will ensure
correct exposure.
• Push the built-in flash down to select
flash cancel ( ).
CUSTOM FUNCTIONS
1 – AF priority
Shutter will not release until or appears in the viewfinder.
Cust 1 – AF Release Priority
Cust 2 – Film Rewind Start
2 – Release Priority
Shutter releases even if the focus cannot be confirmed. Use Release
priority when photographing moving subjects.
• When continuous-advance mode is selected, the camera will not update the
focus while the shutter-release button is pressed.
1 – Automatic
Film is automatically rewound at the end of the roll.
2 – Manual
Press the manual-rewind button to initiate
rewind. (p29).
Cust 3 – Film Tip
1 – Film is completely rewound into the cartridge.
2 – Leader is left out of the
cartridge after rewind.
• Sliding the main switch to LOCK
during rewind causes the film to be
rewound into the cartridge when the
power is switched back on.
To Next Page
Loading...
Need help?
General
