Minolta EP1054 - Fusing Unit; Removal of the Fusing Unit

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
D-40
2-8. FUSING UNIT
(1) Removal of the Fusing Unit
1. Remove one screw and the Ground Wire of the
Fusing Unit.
1151D038AA
2. Unplug the Fusing Heater Lamp connector and
remove the wires from the clamp.
1151D007AA
3. Unplug the Fusing Thermistor connector and
remove the wires from the two clamps.
1151D008AA
4. Remove one screw and the Fusing Unit Locking
Plate.
5. Turning it in the direction of the arrow, remove the
Fusing Unit.
1139D188AA
NOTE
When reinstalling the Fusing Unit, install the Locking
Plate as illustrated on the left.
1139D246AA