FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
D-47
11. Snap off two E-rings to remove the Exit/Duplex
Switching Plate.
1139D214AA
12. Remove one screw and the Photoswitch Mounting
Bracket.
13. Remove two screws and the Exit Rolls Mounting
Bracket Unit.
1139D215AA
NOTE
When reinstalling the Exit Rolls Mounting Bracket Unit,
make sure that the Reinforcement Plate Unit is in con-
tact with the Exit Rolls Mounting Bracket Unit as shown
on the left.
1139D216AA
14. Snap off two E-rings to remove the Exit Roller.
1139D217AA
15. Remove the harness from the clamp.
16. Remove two screws and the Reinforcement Plate
Unit.
1139D218AA
To Next Page
Loading...
