Minolta EP4000 - Page 14

D-7
No. Part Name Removal Procedure
1 Front Door Swing down No. 1.
!
Remove two Front Door hinge shafts.
Remove one belt mounting screw inside the Front Door.
2 Control Panel Raise No. 12.
!
Swing down No. 1.
!
Open No. 8.
!
Re-
move No. 7.
!
Swing down No. 14.
!
Remove No. 13.
!
Remove two control panel mounting screws.
!
Remove two
magnet attraction plate screws.
!
Unplug one connector
from MSC Board.
!
Remove one connector.
3
Original Width Scale Raise No. 12.
!
Remove two scale mounting screws.
Note:When
the
Original
Width
Scale
has
been
removed
use
4
Original Glass
Note:When the Original Width Scale has been removed, use
care not to lose two springs.
5 Rear Upper Cover (Small) Raise No. 12.
!
Open No. 14.
!
Remove No. 13.
!
Re-
move the screw cover.
!
Remove one Rear Upper Cover
(Small) mounting screw.
6 Rear Upper Cover Raise No. 12.
!
Open No. 14.
!
Remove No. 13.
!
Re-
move No. 5.
!
Open No. 8
!
Remove No. 7.
!
Remove
one Rear Upper Cover mounting screw.
7 Right Cover Open No. 8.
!
Open the Multi Bypass Table.
!
Remove
four Right Cover mounting screws.
8 Right Door
(Manual Bypass Unit)
Open No. 8.
!
Remove two cover mounting screws.
!
Remove the harness from one wiring saddle.
!
Unplug
three connectors.
!
Remove two Right Door mounting
screws.
9 Counter Cover Snap off the Counter Cover. (It is secured by catches at two
places.)
10 2nd Drawer <Except 120V Areas>
See
p
. D-17
11 1st Drawer
See
p
.
D
-
17
<120V Areas>
See p. D-18
12 Original Cover Remove No. 12 by pulling up.
13 Upper Left Cover Swing down No. 14.
!
Remove six Upper Left Cover
mounting screws.
14 Left Door (Exit/Duplex
Switching Unit)
See p. D-61
15 Middle Left Cover Remove No. 13.
!
Remove two Middle Left Cover mounting
screws.
16 Rear Cover Remove six Rear Cover mounting screws.