Minolta EP4000 - Page 26

D-19
(6) Removal of the Upper Synchronizing Roller
1156D024AA
1156D025AA
1156D026AA
1156D027AA
Rear
1134D025AA
Front
1. Swing down the Front Door.
2. Swing the Transport Section Release Lever down.
3. Remove the Rear Cover.
4. Unplug the bias terminal from High Voltage Unit HV1.
5. Unplug CN1 of HV1.
6. Remove two screws to free HV1.
7. Snap off one E-ring to free Synchronizing Roller Clutch
CL2.
8. Snap off the E-ring and remove the bushing from the rear
end of the Upper Synchronizing Roller.
9. Swing down the Front Door and slide out the IU.
10. Snap off the E-ring and remove the bushing from the front
end of the Upper Synchronizing Roller.