D-57
23. Loosen the screw that secures the spring bracket at the front and then unhook the spring at the top.
Repeat the same step for the spring in the rear.
NOTE
When reinstalling the springs, alternately tighten the bracket mounting screws until the brackets
completely contact the ends of the Lower Exit Guide Assy.
1156D087AA
1156D088AA
1156D089AA
1156D090AA
24. Remove the Lower Fusing Roller.
25. Remove two extension springs.
26. Remove two E-rings, the gear, bushing, and Cleaning Roll-
er.
27. Remove two E-rings, then two gears.
28. Remove two screws, the Upper Fusing Roller drive gear,
and Upper Fusing Roller.
To Next Page
Loading...
