D-69
(2) ATDC Adjustment
z
Important
Make this adjustment only after the starter has been replaced.
1134D051AA
3. Call the Tech. Rep. mode menu to the screen.
4. Touch
Function to show the Function menu on the screen.
5. Touch
F8 ATDC Adjust
.
6. Press the Start Key to let the copier make the ATDC adjustment. (It will run for about 3 minutes.)
1156D142CA 1156D139CA
NOTES
D While the copier is in the adjustment cycle, the Start Key is lit up orange. The key turns green
as soon as the adjustment cycle is completed.
D Pressing the Start Key will automatically start the ATDC adjustment cycle. Be sure to run
this cycle only after the starter has been replaced.
1. Load the IU with fresh starter.
2. Reinstall the IU in the copier.
To Next Page
Loading...
