D-74
5. Touch
Next
twice to show the “Tech. Rep. Choice 3” menu on the screen.
6. Observing the image density of the sample copy, touch the shift key
A
or
"
to change the setting
for “Image Exposure”.
7. Touch
Enter
to validate the setting.
8. Run the F5 operation again.
D
If the image density is low, decrease the setting value.
D
If the image density is high, increase the setting value.
D
If the image density does not fall within the specifications through one setting, try another
setting.
Setting Instructions
1156D150CA
Touch This Key Twice.
Touch This Key
if ID is High.
Touch This Key
if ID is Low.
1156D146CA
NOTE
Be sure to touch Enter before pressing the Panel Reset Key to return the copier to the Basic screen.
If this is not done, the old setting remains valid.
To Next Page
Loading...
