D-89
(12) Adjustment of the Image Leading Edge Erase Width
z
Requirement
1134D135AA
Dimension A
z
Important
This adjustment should be made after the “adjustment of the leading edge registration” and
“adjustment of the leading edge registration for book second page”.
1136D040AA
3. With the “Adjust 1/2” menu on the screen, touch
Next
to show the “Adjust 2/2” menu.
4. Touch the select key
!
or
"
to highlight “A12 Leading Edge Erase Adjust”.
1156D159CA
1156D166CA
D
The erase width, dimension A, on the copy of the GTC−test
chart should measure 1.0 to 6.5 mm.
D
Setting range: 45 to 55
1. Place the GTC-test chart face down on the Original Glass
and align its rear left corner with the reference marker on
the Original Width Scale. Then, lower the Original Cover.
2. Make three single copies on A3 or 11”
⋅
17” paper in full
size mode and check the third copy for leading edge erase
width.
(If the erase width deviates from the specifications, per-
form the following steps to make the adjustment of image
leading edge erase width.)
To Next Page
Loading...
