Minolta Maxxum 8000i - Power.8; Battery Installation.8

To remove:
1. While pressing the lens release, turn the lens
counterclockwise as far as it will go, then lift
lens out of mount.
2. Attach another lens or the body cap to pre¬
vent dust from entering the camera.
Care of Glass Surfaces
• Never touch lens elements or the camera's
eyepiece with your fingers. If the lens
becomes dirty, clean it gently with a lens
brush. Only if necessary, moisten a sheet of
lens tissue with one drop of lens-cleaning
fluid and, starting at the center and using a
circular motion, lightly wipe the surface of
the lens.
• Never lift the mirror or touch its surface,
since this may impair its alignment. Dust
specks on the mirror's surface will not effect
exposure or picture quality. If dust on the
mirror is distracting, the camera can be
cleaned at an authorized Minolta service fa¬
cility.
7
POWER
This camera uses a 6-volt 2CR5 lithium battery
that supplies power for all camera operations.
Battery installation
1. With the main switch at LOCK, use a coin or
similar object to turn the battery-cover lock to
the OPEN position. Remove the battery cover.
If necessary, wipe the battery terminals with
a dry cloth to ensure proper contact.
2. Insert the battery according to the marks in
the battery compartment.
3. Replace the battery cover and turn the bat¬
tery-cover lock to the CLOSE position.
CAUTION
• Do not disassemble or short-circuit the
battery or subject it to high temperatures or
fire. The battery may explode or cause
burns.
• Read and follow all warnings and instruc¬
tions supplied by the battery manufacturer.
• Keep batteries away from young children.
8