14
1. In VIDEO or PHOTO modes, press the MENU button. Select ‘Date & Time Setup’ by
using the UP or DOWN buttons. Press the OK button to enter the ‘Date & Time Setup’
submenu.
2. The menu is presented as follows:
3. Date: YYYY / MM / DD(the date can only be displayed in this format)
4. Time: HH:MM:SS (the time can only be displayed in a 24-hour format)
5. Press the UP or DOWN buttons to change the any of the values of the date and time.
When you are satisfied with the highlighted value, press the OK button to confirm that
value and proceed to the next value.
Once you are completed, press the MENU button to save your setting and exit. Your
camcorder will return to the main status screen of the current mode.
4.1.17 Parking Monitoring
This setting allows the camcorder to automatically power on and record a video clip if the
camcorder detects a collision while parked and is powered off. You can set the sensitivity
level setting in this menu. This setting will only activate if there is sufficient battery power
remaining in the camcorder’s built-in battery. When triggered or when the camcorder thinks
a collision occurred, it will automatically begin recording and the recording will be stored
with a lock icon. The video file will be locked and protected from deletion.
1. In VIDEO or PHOTO modes, press the MENU button. Select ‘Parking Monitoring’ by
using the UP or DOWN buttons.
2. Press the OK button to turn Parking Monitoring on or off, a check indicates that the
option is activated.
To exit the settings menu, press the MENU button and your camcorder will return to the
main status screen of the current mode.
Note: When off, your camcorder will still automatically record upon startup if you power it
off.
4.1.18 Auto Power Off Delay
This setting allows you to set the length of time before the camcorder powers off
automatically.
1. In VIDEO or PHOTO modes, press the MENU button. Select ‘Auto Power Off Delay’ by
using the UP or DOWN buttons. Press the OK button to enter the ‘Auto Power Off Delay’
submenu.
2. Press the UP or DOWN buttons again to navigate the submenu and select a setting. You
can select from Off, 1 Minute and 3 Minutes.
3. Press the OK button to confirm your selected setting.
4. After the selected amount of time the camcorder will power off.
To Next Page
Loading...
