7
3. CAMCORDER OPERATION
Once you have inserted the MicroSD memory card and plugged your camcorder into a
power source, your camcorder will automatically power on and begin recording. Press the
OK button to stop recording. You may also manually power your camcorder on or off by
pressing the POWER button for 2 seconds.
There are 3 operation modes available for use. To cycle through the different modes,
simply press the MODE button. Your camcorder’s screen will show the current mode in the
display’s upper left corner. Modes cannot change while a video is being recorded. The
recording must stop first before changing to another mode.
3.1 Video Capture Mode
Once your camcorder powers on, it will default to Video Mode and will begin recording
automatically. To start or stop recording at any time, press the OK button. Press the
DOWN button to change the view of the rear camera.
3.2 Photo Capture Mode
To capture a photo, enter PHOTO Mode by pressing the MODE button until a camera icon
is show in the upper left corner of the screen. Press the OK button to instantly capture a
photo.
3.3 Playback Mode
To review your video and photo files, enter PLAYBACK Mode. Press the MODE button
until a previously captured file is shown on the screen. The most recent file captured will be
displayed first.
1. Press the UP and DOWN buttons to cycle through available playback files of photos and
videos.
2. To delete a file or to protect a file from deletion, press the MENU button.
3. Press the MODE button again to exit PLAYBACK mode.
Playing Back Video Clips
1. Press the OK button to play or pause a video clip in PLAYBACK mode.
2. To delete a file or to protect a file from deletion, press the LOCK FILE button.
To Next Page
Loading...
