Minolta MNCD337N - 1.7.3 USB Cord; Computer Use; 1.7.4 Using the IR Night Vision Mode; 1.7.5 Reset; 2. USING YOUR CAMCORDER

6
1.7.3 USB Cord / Computer Use
Connect the included USB cable to a free USB port on your computer, and connect the
other end of the cable into the camcorder’s USB port. The battery may be charged while
the camcorder is powered on or off. The camcorder will automatically power on and show
three different modes you can select from. The modes are ‘Memory’, where you can
access stored videos and images, ‘PC camera’, where the camcorder will function like a
web cam, and ‘Video’, where the camcorder will function normally. Use the UP or DOWN
buttons to select your desired mode and press the OK button to enter that mode.
Your camcorder acts like a memory card reader when connected and your videos and
photos stored on your camcorder memory can easily be accessed this way.
To access the files on your PC, go to Start (or File Explorer) → This PC → and find
Removable Disk. Your media will be stored in a folder on this drive.
1.7.4 Using the IR Night Vision Mode
This camcorder has built-in infrared (IR) LEDs for night vision recording - giving you the
ability to capture photos and videos in a dark environment.
The infrared LEDs automatically activate when the level of ambient light is low and will turn
off when the level of ambient light is high.
1.7.5 Reset
If your camcorder freezes or becomes unresponsive, press the RESET button to reset
and power cycle the camcorder. Insert a pointy object into the reset hole on the front body
of the camcorder to fully reset it. Refer to the Section 1 of the user manual’s illustration.
2. USING YOUR CAMCORDER
Quick Use Instructions
Simply insert the memory card into the card slot, and insert the auxiliary power adaptor into
the camcorder’s USB port and your car’s power port. The camcorder will automatically
power on and begin recording a video file.
To start or stop recording at any time, press the OK button. You may also remove the
auxiliary DC power adaptor at any time to automatically save a recording and power the
camcorder off. Just mount it to your windshield, plug in the power and drive!