17
4.3.3 Auto Power Off Delay
This setting allows you to set the length of time before the camcorder powers off
automatically if the camcorder does not receive any input such as pressing a button or
recording.
1. In VIDEO or PHOTO modes, press and hold the MODE button to access the settings
menu. Then press the MODE button again to access the Setup mode settings.
2. Select ‘Auto Power Off Delay’ by using the LEFT or RIGHT buttons. Press the OK button
to enter the ‘Auto Power Off Delay’ submenu.
3. Press the LEFT or RIGHT buttons again to navigate the submenu and select a setting.
You can select from Off, 1 Minute and 3 Minutes.
4. Press the OK button to confirm your selected setting.
5. After the selected amount of time, without any input, the camcorder will power off.
6. To exit the settings menu, press the MODE button and your camcorder will return to the
main status screen of the current mode.
4.3.4 Screen Saver
This setting allows you to set the length of time before the LCD Screen turns off
automatically if the camcorder does not receive any input in the form of pressing a button.
1. In VIDEO or PHOTO modes, press and hold the MODE button to access the settings
menu. Then press the MODE button again to access the Setup mode settings.
2. Select ‘Screen Saver’ by using the LEFT or RIGHT buttons. Press the OK button to
enter the ‘Screen Saver’ submenu.
3. Press the LEFT or RIGHT buttons again to navigate the submenu and select a setting.
You can select from Off, 3 Minutes, 5 Minutes and 10 Minutes.
4. Press the OK button to confirm your selected setting.
5. After the selected amount of time the camcorder LCD screen will power off.
6. To exit the settings menu, press the MODE button and your camcorder will return to the
main status screen of the current mode.
4.3.5 Beep Sound
This setting allows you to enable or disable the sound when pressing a button.
1. In VIDEO or PHOTO modes, press and hold the MODE button to access the settings
menu. Then press the MODE button again to access the Setup mode settings.
2. Select ‘Beep Sound’ by using the LEFT or RIGHT buttons. Press the OK button to enter
the ‘Beep Sound’ submenu.
3. Press the LEFT or RIGHT buttons again to navigate the submenu and select a setting.
You can select from Off and On.
4. Press the OK button to confirm your selected setting
To Next Page
Loading...
