9
4. MENU & SETTINGS INTERFACE
4.1 Video Mode Settings
Overview
Your camcorder comes preset with some user-adjustable settings to fine tune and customize
how you would like your videos to be captured. The settings are already optimized and preset
for the easiest experience.
Before you begin, ensure you are in VIDEO mode . From the main screen, press the
MODE button once. The current mode will be displayed in the upper left corner of the display.
To cycle through the different modes, simply press the MODE button again. The view from the
rear camera can be seen and recorded in video mode. Press the DOWN button to change the
view of the rear camera.
NOTE: The settings menu cannot be accessed while the camcorder is recording a video file.
If the camcorder is recording a file, you must stop recording before the settings menu can be
accessed. To stop recording at any time, press the OK button.
4.1.1 Video Resolution
Your camcorder has a number of preset resolution and frames per second rates. A higher
resolution will produce a higher quality and lager video file.
1. In VIDEO mode, press the MENU button. Select ‘Video Resolution’ by using the UP or
DOWN buttons. Press the OK button to enter the ‘Video Resolution’ submenu.
2. Press the UP or DOWN buttons again to navigate the submenu and select a setting.
You can select from 1080FHD 1920X1080 (highest quality), 1080P 1440X1080 (Higher
Quality), 720p 1280X720 (medium quality), WVGA 848X480 (low quality), and VGA
640X480 (lowest quality).
3. Press the OK button to confirm your selected setting.
To exit the settings menu, press the MENU button twice and your camcorder will return to the
main status screen of the current mode.
4.1.2 Loop Recording
This setting allows you to set a maximum duration for each video clip recorded. Once you
select an option, your camcorder will record video clips in this time interval only. Once your
selected duration recording time is reached, the camcorder will end the recording and begin
recording a new video file seamlessly.
To Next Page
Loading...
