17
4.4 Setup Settings Menu
Overview
The Setup Settings Menu can be accessed while in any mode. From the main screen, press
the MENU button twice. The menu will move right and switch tabs from the current mode’s
icon to the Setup Settings menu.
NOTE: The settings menu cannot be accessed while the camcorder is recording a video file. If
the camcorder is recording a file, you must stop recording before the settings menu can be
accessed. To stop recording at any time, press the OK button.
4.4.1 Park Mode Sensitivity
This setting allows the camcorder to automatically power on and record a video clip if the
camcorder detects a collision while parked and is powered off. You can set the sensitivity
level setting in this menu. This setting will only activate if there is sufficient battery power
remaining in the camcorder’s built-in battery. When triggered or when the camcorder thinks a
collision occurred, it will automatically begin recording and the recording will be stored with
the icon. The video file will be locked and protected from deletion.
1. In VIDEO mode, press the MENU button. Select ‘Park Mode Sensitivity’ by using the
UP or DOWN buttons. Press the OK button to enter the ‘Park Mode Sensitivity’
submenu.
2. Press the UP or DOWN buttons again to navigate the submenu and select a setting.
You can select from Off, Low, Medium and High.
3. Press the OK button to confirm your selected setting.
To exit the settings menu, press the MENU button twice and your camcorder will return to the
main status screen of the current mode.
Note: When selecting Off, your camcorder will still automatically record upon startup if you
power it off.
4.4.2 Date & Time Setup
This setting allows you to set a date and time for display on videos and photos.
1. In any mode, press the MENU button twice. Select ‘Date & Time Setup’ by using the
UP or DOWN buttons. Press the OK button to enter the ‘Date & Time Setup’ submenu.
2. The menu is presented as follows:
Date: MM / DD / YYYY (the date can only be displayed in this format)
Time: HH:MM:SS (the time can only be displayed in a 24-hour format)
To Next Page
Loading...
