Minolta MNCD50 - MNCD50 Dash Cam Operation; Quick Usage Instructions; Powering On and Off; Switching Between Modes

Quick Use
Simply insert a MicroSD card into the MicroSD card slot, and insert the auxiliary power adaptor into
the camera’s USB port and your car’s power port. The camcorder will automatically power on.
Remove the auxiliary power adaptor to automatically save a recording and power the camcorder off.
To start or stop recording at any time, press the RECORD button.
CAMCORDER OPERATION
Press the POWER button to power the camcorder on. The camcorder will automatically begin
recording video if a MicroSD card is inserted in the card slot and motion detection has been enabled,
or the G-sensor sensitivity is enabled. Press the power button for 5 seconds to manually power off.
To switch between video, photo and playback modes, simply press the MODE button.
MODE icons are displayed in the upper left corner of the screen. Press the RECORD button to begin
recording video or to capture a photo.
VIDEO Mode PHOTO Mode