Minolta PagePro 1100 - Resetting the Counter for the Image Transfer Roller; Cancelling a Print Job

7
Working with the printer
7-6
Resetting the counter for the image transfer roller
After you have replaced the image transfer roller, reset the counter for the
image transfer roller.
1
Switch off the printer.
2
Hold down the control button and switch on the printer again.
The green “Stand-by“ lamp begins to flash.
3
Hold down the control button for another 5 seconds and then
release it.
All three lamps begin to flash.
4
Briefly press the control button again.
The amber “Fault“ lamp continues to flash. The other lamps go out.
After a few seconds, all three lamps begin to flash.
The counter for the image transfer roller has now been reset.
5
Switch the printer off and then on again.
Once the green “Stand-by“ lamp remains on permanently, the printer
is again in Stand-by mode.

The counter can also be reset via the software!
The image transfer roller counter can also be reset via the “Counter“
function, see chapter 5.
Cancelling a print job
This cancels the print job currently being processed.
1
Hold down the control button for longer than 5 seconds.
2
Release the control button after all three lamps have gone out.
The current print job has now been cancelled.