Mintek MDP-1760 - Page 5

(14)PowerLines-Anoutsideantenna
systemshouldnotbelocatedinthe
vicinityofoverheadpowerlinesorother
electriclightorpowercircuits,orwhere
itcanfallintosuchpowerlinesorcircuils.
Wheninstallinganoutsideantenna
system,extremecamshouldbetaken
tokeepfromtouchingsuchpowerlines
orcircuitsascontactwiththemmightbe
fatal.
(15)Overloading-Donotoverloadwall
outlets,extensioncords,orintegral
conveniencereceptaclesasthiscan
resultinariskoffireorelectricshock.
(16)ObjectandLiquidEntry-Neverpush
objectsofanykindintothisproduct
throughresultinafireorelectricshock.
Nevrespillliquidofanykindonthe
product.
(17)Servicing- Donotattempttoservice
thisproductyourselfasopeningor
removingqualifiedservicepersonnel.
(18)DamagesRequiringService-Unplug
thisproductfromthewalloutletand
referservicingtoqualifiedservice
personnelunderthefollowingconditions.
a)Whenthepower-supplycordorplugis
damaged.
b)If liquidhasbeenspilled,orobjectshave
fallenintotheproduct.
c)If theproducthasbeenexposedtorainor
water.
d)Iftheproductdoesnotoperatenormally
byfollowingtheoperatinginstructions.
Adjust only those controls that am covered
by the operating instructions as an improper
adjustment of other controls may result in
damage and will often require extensive
work by a qualified technician to restore
the product to its normal operation.
e) If the product has been dropped or
damaged in any way.
f) When the product exhibits a distinct
change in performance - this indicates a
need for service.
(19) Replacement parts - When replacement
parts are required, be sure the service
technician has used replacement parts
specified by the manufacturer or have
the same characteristics as the original
part. Unauthorized substitutions may
result in fire, electric shock or other hazaMs.
(20) Safety Check - Upon completion of any
service or repair to this product, ask the
service technician to perform safety
checks to determine that the product is
in proper operating condition.
(21) Heat - The product should be situated
away from heat sources such as radiators,
heat registers, stoves or other products
(including amplifiers) that produce heat.
(22) During playback, few bright or dark
flecks may appear on the TFT LCD,
which is a normal phenomenon in
active matrix display technology, but
not a malfunction.
.5.