z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
Connect the equipment int
z o an outlet on a circuit different from that to which
ed by the manufacturer could
s authority to operate the equipment.
f a non-shielded interface cable with this equipment is prohibited.
ements of the Canada
respecte toutes les exigences du Règlement
l brouileur.
issued by the Commission
with these directives implies conformity to the following European
ces;
ervices;
evices (SRD) operating on
the receiver is connected.
z Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approv
void the user’
Please note:
The use o
Canada
Canadian Department Of Communications
Radio Interference Regulations Class B Compliance Notice
This Class B digital apparatus meets all requir
Interference-Causing equipment regulations.
Cet appareil numérique de Classe B
Canadien sur le matérie
European Notice
Products with the CE marking comply with Radio & Telecommunication
Terminal Equipment Directive (R&TTE) (1999/5/EEC), the Electromagnetic
Compatibility Directive (89/336/EEC) and the Low Voltage Directive
(73/23/EEC) – as amended by Directive 93/68/ECC -
of the European Community.
Compliance
Standards:
EN301489-1: Electronic compatibility and Radio spectrum Matters (ERM),
ElectroMagnetic Compatibility (EMC) standard for radio equipment and servi
Part 1: Common technical requirements
EN301489-3: Electronic compatibility and Radio spectrum Matters (ERM),
ElectroMagnetic Compatibility (EMC) standard for radio equipment and s
Part 3: Specific conditions for Short-Range D
frequencies between 9 kHz and 40 GHz
18
To Next Page
Loading...
