Deployment Guidelines
1. Determine which traffic pole you will use to mount the SmartView 360. This is
typically the traffic pole nearest your traffic cabinet, but could be a different
traffic pole to meet these requirements:
○ It must be the traffic pole nearest the intersection.
○ It must be a hollow traffic pole or mast arm with access to run cabling
inside the pole. If you must mount SmartView 360 on a solid traffic pole, a
weatherproof junction box is required.
○ The line of sight from the camera must not be obstructed by signal heads,
mast arms, signs, trees, or other objects.
2. Determine where on the traffic pole you will install the SmartView 360, including
whether you will install it on a mast arm. The minimum recommended
installation height is 9.14 m (30 ft). You must supply a pole extender if the
planned pole is not tall enough.
3. Determine the size of your intersection by measuring from the base of the traffic
pole where the camera will be installed to the most distant location where you
want to detect objects.
○ In Google satellite view, you can do this by right-clicking at the base of the
pole where you want to install SmartView 360, clicking Measure Distance,
and then clicking the most distant location where you want to detect
objects. Make sure that you measure to the back the detection zone, not
to the corner of the intersection. As you consider different camera
locations, you can drag the two points around to update the distance.
For example, in this intersection the most distant detection zone is
displayed at the top of the image.
6.11.19
8
To Next Page
Loading...