1111
1111
11
Section
5
SpecificationsSpecifications
SpecificationsSpecifications
Specifications
1. Plumbing1. Plumbing
1. Plumbing1. Plumbing
1. Plumbing
1.1.1.1.
1.1.1.1.
1.1. The inlet connector assembly incorporates an inlet filter, which swivels to allow
these entry positions, top, top back, bottom and bottom back inlet.
1.2.1.2.
1.2.1.2.
1.2. The outlet terminates with a 1/2" BSP male thread for connection to a Mira
flexible shower hose.
1.3.1.3.
1.3.1.3.
1.3. A maintained pressure of at least
1 bar1 bar
1 bar1 bar
1 bar is recommended for the product up to a
maximum static pressure of
10 bar10 bar
10 bar10 bar
10 bar.
Thermostatic performance will be maintained down to
0.5 bar0.5 bar
0.5 bar0.5 bar
0.5 bar maintained
pressure. However, this will result in reduced power and therefore reduced flow.
1.4.1.4.
1.4.1.4.
1.4. The Mira Advance will provide satisfactory performance with incoming water
supply temperatures between 2°– 28°C.
1.5.1.5.
1.5.1.5.
1.5. Maximum ambient temperature for the Mira Advance whilst in use is 30°C.
2. Electrical2. Electrical
2. Electrical2. Electrical
2. Electrical
2.1.2.1.
2.1.2.1.
2.1. Mira Advance supply fuse - 8.7 kW 40 Amp
9.8 kW 45 Amp
2.2.2.2.
2.2.2.2.
2.2. The terminal block will not accept cable larger than 16 mm
2
.
2.3.2.3.
2.3.2.3.
2.3. The Mira Advance will provide satisfactory performance with an incoming
electricity supply voltage of 230 V ± 10%.
3.3.
3.3.
3.
Standards and Appro Standards and Appro
Standards and Appro Standards and Appro
Standards and Appro
vv
vv
v
alsals
alsals
als
3.1.3.1.
3.1.3.1.
3.1. The Mira Advance has been designed to comply with the requirements of the
British Electrotechnical Approvals Board (BEAB) and the requirements of UK
Water Regulations/Bylaws (Scotland).
3.2.3.2.
3.2.3.2.
3.2. This Mira Advance complies with all relevant directives for CE marking.
To Next Page
Loading...
Need help?
General
