Mira Advance User Manual

1616
1616
16
Section
7
InstallationInstallation
InstallationInstallation
Installation
1.1.1.1.
1.1.1.1.
1.1. To remove the Mira Advance case
remove the screw at the bottom of
the case.
1.2.1.2.
1.2.1.2.
1.2. Pull the bottom of the Mira Advance
cover outwards and upwards off the
case.
1.3.1.3.
1.3.1.3.
1.3. Slide out the inlet shield, located
over the inlet connector assembly.
1.4.1.4.
1.4.1.4.
1.4. Unscrew the transit sealing caps from
the inlet and outlet of the Mira
Advance.
1.5.1.5.
1.5.1.5.
1.5. When installing the Mira Advance
with concealed water and electrical
supplies refer to
, "Dimensions:, "Dimensions:
, "Dimensions:, "Dimensions:
, "Dimensions:
Water and cable entry points".Water and cable entry points".
Water and cable entry points".Water and cable entry points".
Water and cable entry points".
1.1.
1.1.
1.
Mir Mir
Mir Mir
Mir
a Adva Adv
a Adva Adv
a Adv
anceance
anceance
ance
Read the section
"Important Safety Information""Important Safety Information"
"Important Safety Information""Important Safety Information"
"Important Safety Information" first.
WARNING!WARNING!
WARNING!WARNING!
WARNING! Isolate the electrical and water supplies before proceeding with the
installation of the Mira Advance.
Note!Note!
Note!Note!
Note! Bottom inlet is illustrated for clarity in these instructions.
Screw
Wire 78 Multi-
connector Inlet Shield
Transit
Sealing Cap
(outlet)

Mira Advance Specifications

General

Temperature Control	Thermostatic
Warranty	2 Years
Power Ratings	9.8 kW
Water Connection	15 mm
Outlet Connection	1/2"
Water Pressure	0.7 - 10 bar
Cable Entry Points	Bottom entry
Safety Features	Overheat protection
Approvals	WRAS