Mira Azora Installation And User Guide

201062243-W2-N
Using your Shower
Readthesection“UserSafetyInformation”rst.
Note: At the end of every shower make sure that the shower head points
into the catchment area. A small amount of water may be retained in the
shower handset after the shower has been turned o󰀨. This may drain over
a few minutes.
Press the ‘Start/Stop’ button.
2.
Switch on electrical supply.
1.
Set to desired position.
3.
Residualwatermaydrain
over a few minutes.
8.
4.
Check water temperature before
entering shower.
5.
Allow 10 - 15 seconds for any temperature adjustments to reach the handset.
6.
Press STOP button.
Shower will continue to run
for a few seconds before
stopping.
7.
Isolate power.
_
+
_
+

Mira Azora Specifications

General

Brand	Mira
Model	Azora
Category	Plumbing Product
Language	English