EasyManuals Logo

Mira Azora Installation And User Guide

Mira Azora
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
221062243-W2-N
Fault Diagnosis
The trouble shooting information tabled below gives details on probable causes
andremediesshoulddi󰀩cultiesbeencounteredwhilsttheshowerisinoperation.
Warning! There are no user serviceable components beneath the cover of the
appliance. Only a competent tradesperson should remove the front cover!
Symptom Start/
Stop
Light
Heater
Setting
I / II / III
Probable Cause Possible Remedy
Appliance Fails
to operate
OFF ANY
Electrical supply isolated at
double pole switch.
Switch on electrical supply via
the pullcord or wall mounted
switch.
Fuse blown or MCB/RCD
tripped, indicating possible
electrical fault.
Renew the fuse or reset the
MCB/RCD. If fault persists,
contact your installer.
Shower cycles
from hot to cold
ON II / III
Showerhead blocked Removeandclean.
Water pressure below
minimum required for appliance
operation.
Make sure incoming mains
water stopcock and/or
appliance isolating valve is
fully turned on.
Temperature dial or Heater
setting too high.
Turn the heater selector
knob to setting II or turn the
temperature control until a
cooler temperature is achieved.
Thermostatic mechanism is
faulty or damaged.
Replace.
Unable to
select a
cool enough
shower.
ON III
Due to the rise in mains water
supply temperature, the Heater
setting may be too high.
Turn the heater selector knob
to II and adjust the temperature
control until a suitable
temperature is achieved.
Unable to
select a
hot enough
shower (cold
only)
ON I / II Power control not on high Turn the power control to high
ON ANY
Temperature control on cool
setting
Turn the temperature control
until a hotter temperature is
achieved
Water pressure below
minimum requirement for
shower operation
Make sure incoming mains
water stopcock and / or
shower isolating valve is fully
open
Contact water company
Showerhead blocked Removeanddescale
showerhead
Hose kinked or blocked Check hose and replace
if necessary, see section -
USER MAINTENANCE’.
RestrictioninShowerhead
mode
Selectdi󰀨erentShowerhead
mode

Other manuals for Mira Azora

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mira Azora and is the answer not in the manual?

Mira Azora Specifications

General IconGeneral
BrandMira
ModelAzora
CategoryPlumbing Product
LanguageEnglish

Related product manuals