Mira Azora Installation And User Guide

23
1062243-W2-N
Symptom Start/
Stop
Light
Heater
Setting
I / II / III
Probable Cause Possible Remedy
Handset
dripping
OFF ANY
Insufficient water supply
pressureforshuto󰀨.
The minimum static pressure
toensureshuto󰀨andprevent
dripping is 0.2 bar.
Note! If other appliances are
operating, static pressure may
drop below 0.2 bar. Contact
local water company. Renew
the Flow Valve.
Inlet valve faulty Replace
Lowornoow.
ON ANY
Water supply pipework or inlet
lterrestrictedbyablockageor
partial blockage.
Flush supply pipe. Clean inlet
lter.
Insufficient water supply
pressure/owforoperation.
Contact local water company.
Supply pressure must be a
minimum of 0.7 bar.Note: If
other appliances are operating,
pressure may drop below 0.7
bar.
Other outlets (e.g. toilet, garden
hose, washing machine, etc.)
drawing water while the shower
is being used.
Turno󰀨otherapplianceswhilst
shower is in use.
Showerhead blocked. Removeandclean.
OFF ANY
Service tunnel or cover not
tted correctly causing Start/
Stop button not to operate.
Check case inserts are cut and
ttedcorrectly.Checkservices
(electrical or plumbing) are
not interfering with location of
service tunnel or cover.
ON ANY
Inlet Valve faulty. Replace.
Heater Tank excessively
scaled.
Replace. In hard water areas
consider the use of a water
softener.
Operation of
temperature
control has
little or no
e󰀨ectonwater
temperature.
ON II / III
Showerhead or inlet filter
blocked.
Removeandclean.
Inlet valve faulty. Replace.
Heater tank failure. Replace.
Microswitch failure. Replace.

Mira Azora Specifications

General

Brand	Mira
Model	Azora
Category	Plumbing Product
Language	English