Turn the water supply back off. Feed
the electrical cable into the shower
unit. Strip the insulation and t an earth
sleeve (not supplied). Secure the wires
rmly into the terminal block.
Install the shower ttings provided with
this shower, see “Installation of the
Shower Fittings”.
The shower must be commissioned
before use, see “Commissioning” for
full instructions.
Ret the service tunnel. Align the
controls with the spindles and ret the
cover. Secure with screws supplied.
DO NOT trap any wires.
DO NOT use alternative screws to
secure the cover. This can cause
internal damage to the shower unit.
(Neutral) = Blue Wire
(Live) = Brown Wire
(Protective Earth) =
Green / Yellow
Sleeved Wire
N
L
11
1312
10
To Next Page
Loading...
