Mira Elite QT - User Maintenance; Cleaning and Filter Replacement

22
1265606-W2-A
Cleaning / Replacing Filter
The lter can be safely removed from the lower left of the shower unit. Isolate the electrical
supply to the shower unit before removing the lter. The water supply will shut off automatically
as the lter is removed, however we recommend isolating the water supply to the shower unit
to aid with retting the lter.
Insert a suitable coin or an 8 mm hexagonal
key into the cap and turn to the left.
Rinse the lter in clean warm water removing
any dirt or debris. Replace if the lter mesh
is damaged. Make sure the lter is correctly
retted to the locked position.
21
User Maintenance
WARNING! PLEASE OBSERVE THE FOLLOWING TO REDUCE
THE RISK OF FIRE, ELECTRIC SHOCK, INJURY OR PRODUCT
DAMAGE:
■ No user serviceable parts can be accessed by removing the cover.
Mains connections are exposed when the cover is removed. Only
qualied, competent personnel should remove the cover.
■ Isolate the electricity to the shower unit before cleaning or
performing any user maintenance.
■ DO NOT allow children to clean or perform any user maintenance
to the shower unit without supervision.
■ DO NOT use the showerhead to clean the shower unit.
■ If the shower is not to be used for a long period, the electrical
supply and water supply to the shower unit should be isolated.
If the shower unit or pipework is at risk of freezing during this
period, a qualied, competent person should drain them of water.
Cleaning
Many household cleaners contain abrasives and chemical substances, and should not be used
for cleaning plated or plastic ttings. These nishes should be cleaned with a mild washing
up detergent or soap solution, and then wiped dry using a soft cloth.
Locked
position