Mira Select Flex - Operation

21
OPERATION
The Mira Select Flex is a thermostatic mixer
with separate control levers for on/off and
temperature.
OFF
Turn the Temperature Control
Lever clockwise to decrease
th e te mp era tu re a nd
anticlockwise to the preset
maximum temperature
Turn the Flow Control
Lever anticlockwise to
the preset maximum ow
ON
Warmer
Cooler
4. Unscrew the two backplate screws and remove
the backplate.
5.
Pull off the red ow lever adaptor.
6. Locate the ‘O’ Key (supplied) onto the cartridge
nut and turn anticlockwise. Unscrew fully and
pull the thermostatic cartridge from the mixing
valve.
Thermostatic
Cartridge
‘O’ Key
Flow Lever Adaptor
Backplate
7. Rotate the thermostatic cartridge 180°.
8. Make sure that the two inlet seals are tted
and carefully push the thermostatic cartridge
back into the mixing valve, aligning the lugs
into the slots.
Note! Check that the cartridge lug stamped
‘H’ is aligned with the hot inlet supply.
Important! Take care when fitting the
thermostatic cartridge. Damage to the cartridge
inlet seals may result in dripping from the
showerhead.
9.
Tighten the nut by turning the ‘O’ key
clockwise.
10.
Ret the controls in reverse order.
Note! When retting the bearing, make sure
that the cutouts are aligned with the control
assembly.
11.
Before using the shower, refer to section:
‘Commissioning’.