-- -- 5
6. ANT
The antenna can be connected directly here. For duplex
operation, use a dual band antenna (144/440 MHz) which
is fine tuned on both bands. Two mono-band antennas
can also be used by connecting them through a duplexer
unit.
7. TX (RF INPUT)
This is a BNC connector that should be connected
directly to the handy-transceiver.
8. DOCKING ADAPTOR
There are various adaptors suitable for different models
of handy-transceivers.
9. MOUNTING BRACKET
The mounting bracket allows easy attachment of your
BD-25 to your car.
10. ADAPTER POWER SWITCH
The adaptor power can be turned OFF (middle position)
when the amplifier is not in use. You can select the
adaptor to be 10.8V (left position) for new HT models or
13.8V (right position) for older models depending on
your HT.
To Next Page
Loading...
