Mirage IAPH301A - Function Introduction for Combination Buttons

12
Press “TIMER ON” to conrm it. The word “ON” will stop blinking.
“ “ icon resumes displaying. Cancel TIMER ON: Under the condition that
TIMER ON is started up, press “TIMER ON” button to cancel it.
• TIMER OFF button
“TIMER OFF” button can set the time for timer o󰀨. After pressing this button,
” “ icon disappears and the word “OFF” on remote controller blinks.
Press “▲” or “▼” button to adjust TIMER OFF setting. After each pressing
“▲” or “▼”button, TIMER OFF setting will increase or decrease 1min. Hold
“▲” or “▼” button, 2s later, the time will change quickly until reaching your
required time.
Press “TIMER OFF” word “OFF” will stop blinking. “ “ icon resumes
displaying. Cancel TIMER OFF. Under the condition that TIMER OFF is
started up, press “TIMER OFF” button to cancel it.
Note:
• Under on and o󰀨 status, you can set TIMER OFF or TIMER ON
simultaneously.
• Before setting TIMER ON or TIMER OFF, please adjust the clock time.
• After starting up TIMER ON or TIMER OFF, set the constant circulating
valid. After that, air conditioner will be turned on or turned o󰀨 according to
setting time. ON/OFF button has no e󰀨ect on setting. If you don’t need this
function, please use remote controller to cancel it.
Function introduction for combination buttons
Energy-saving function
Under cooling mode, press “TEMP” and “ CLOCK” buttons simultaneously
to start up or turn o󰀨 energy-saving function. When energy-saving function
is started up, “SE” will be shown on remote controller, and air conditioner will
adjust the set temperature automatically according to ex-factory setting to
reach to the best energy-saving e󰀨ect. Press “TEMP” and “CLOCK”buttons
simultaneously again to exit energy-saving function.
Note:
• Under energy-saving function, fan speed is defaulted at auto speed and it
can’t be adjusted.
• Under energy-saving function, set temperature can’t be adjusted. Press
“TURBO” button and the remote controller won’t send signal.
• Sleep function and energy-saving function can’t operate at the same time. If
energy-saving function has been set under cooling mode, press sleep button
wil cancel energy-saving function. If sleep function has been set under
cooling mode, start up the energy-saving function will cancel sleep function.
Introduction for buttons on remote controller screen