EasyManua.ls Logo

Mircom FA-301-8LW - Command Menu;Dialer Config->Telephone Line

Mircom FA-301-8LW
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
82
Configuration with the CFG-300 LCD Service Tool
11.11.2 Command Menu/Dialer Config-->Telephone Line
Note: Refer to 11.2.1 Using the Keypad to Program the FA-300 on page 61 for detailed
instructions on making menu selections.
Command Menu/Dialer-Config/Telephone Line
1. Line#1 Dialing Type
[X] DTMF Dial->Default
[ ] Pulse Dial
Set the dialing type for line
#1; this is the type
recognized or preferred by
the telephone company.
Command Menu/Dialer-Config/Telephone Line
2. Line#2 Dialing Type
[X] DTMF Dial->Default
[ ] Pulse Dial
Same as Line#1.
Command Menu/Dialer-Config/Telephone Line
3. Line#1 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Use this menu to let the
system know whether or not
to wait for a dial tone before
dialing. Cell phone setup for
the dialer requires that the
system not wait for dial tone
before dialing.
Command Menu/Dialer-Config/Telephone Line
4.Line#2 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Same as Line#1.
Command Menu/Dialer-Config/Telephone Line
5.Number of retries
06 ->Default
Set the number of retries for
both line#1 and line#2. This
function lets the dialer retry
on either line if it is busy or
not available. If the retry
count expires, the panel
reports a line trouble.
i
1 Line1 Dialtype
2 Line2 Dialtype
3 Line1 Dialtone
4 Line2 Dialtone
- Telephone Line -
5 Num of Retries
Line#1 Dialing Type:
[X] DTMF Dial
Line#2 Dialing Type:
[X] DTMF Dial
Line#1 Wait Dialtone
[X] ENABLE
Line#2 Wait Dialtone
[X] ENABLE
Number of Retries:
06

Table of Contents

Other manuals for Mircom FA-301-8LW

Related product manuals