What to do if my Mircom Control Panel shows a Battery/Charger Trouble?
If your Mircom Control Panel indicates a Battery/Charger Trouble, it might be due to low voltage (below 20.4V). First, check if the batteries are present and in good condition. If the problem continues, replace the batteries as soon as possible. If the issue still persists after replacing the batteries, the main board may need replacement.
How to troubleshoot a Common Trouble on a Mircom Control Panel?
To troubleshoot a Common Trouble on your Mircom Control Panel, check for any missing interconnection wiring and any missing modules that are part of the configuration. Also, verify the jumper positions, ensuring that the continuity jumper is installed only on the last circuit adder module in the system. Finally, check for improperly secured cabling.
What to do if my Mircom Control Panel displays a Ground Fault?
If your Mircom Control Panel is showing a Ground Fault, check for any external wiring that might be touching the chassis or any other earth ground connection.
How to fix a Circuit Trouble on a Mircom Control Panel?
To fix a Circuit Trouble on your Mircom Control Panel, check for open wiring on that particular circuit loop or see if the circuit disconnect switch is in the ON or CLOSED position.
Why is my Mircom Control Panel stuck in Configuration Mode?
If your Mircom Control Panel is stuck in Configuration Mode, it's likely that the configuration has been corrupted. You must review and re-enter your configuration.
Configuration and settings for the main fire alarm module.
Explains terminal connections for the main fire alarm module.
Details terminal connections for the DM-1008A module.
Instructions for connecting power supplies to the system.
Common messages, descriptions, and troubleshooting steps.
Step-by-step guide to entering configuration mode.
Restoring system to default or resizing configurations.
How to configure initiating and indicating circuit types.
Verifying circuit wiring using walk test mode.
General| Output Voltage | 24 VDC |
|---|---|
| Auxiliary Relays | 1 |
| Power Supply | 24 VDC |
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| Battery Backup | 24 hours |
To Next Page