32
Module Settings
5.6 RM-1008A Relay Adder Module
Figure 15 Relay Adder Module (Model RM-1008A)
• Jumper JW6 on the main fire alarm module must be removed if there are any adder
modules installed.
• The RM-1008A requires eight display points.
JW1 Remove continuity jumper if there are any more adder modules installed.
Note: To have all relays work independently remove all jumpers off of their pins. To tie
all commons together, have all pins in place on their respective jumpers.
P1
P3
P4
FIELD WIRING TERMINALS
P2
JW1
Data cable to P5 of main
re alarm module or to
previous adder module
Data connector for next
adder module
Power connector to
P6 of main re alarm
module or to previous
adder module
Power connector for
next adder module
JP1
JP2
JP3
JP4
JP5
JP6
JP7
JP8
To Next Page
Loading...
