What to do if Mircom Control Panel shows battery trouble?
If your Mircom Control Panel indicates a battery trouble, it means the voltage is low (below 20.4V). The solution is to replace the batteries as soon as possible.
How to fix a ground fault on a Mircom Control Panel?
To resolve a ground fault on your Mircom Control Panel, check for any external wiring touching the chassis or other Earth Ground connection.
What causes common trouble on a Mircom Control Panel, and how to resolve it?
Common trouble on a Mircom Control Panel can arise from a few potential issues: missing interconnection wiring, a missing module that was part of the configuration, or improperly secured cabling. Check each of these to resolve the problem.
How to troubleshoot a circuit trouble on a Mircom FA-301-8LW Control Panel?
To troubleshoot a circuit trouble on your Mircom Control Panel, check for open wiring on that particular circuit loop. Also, ensure that the Circuit Disconnect Switch is in the ON or CLOSED position.
General| Brand | Mircom |
|---|---|
| Model | FA-301-8LW |
| Category | Control Panel |
| Language | English |
Illustrates cable connectors and jumper settings on the main fire alarm board.
General guidance for wiring devices to the main fire alarm board terminals.
Wiring diagrams for Class B (Style B) initiating circuits.
Wiring diagrams for Class A (Style D) initiating circuits using ICAC-306 module.
Wiring for Class B (Style Y) and Class A (Style Z) indicating circuits.
Wiring diagram for four-wire smoke detectors.
Wiring instructions for the on-board dialer for specific panel models.
Wiring diagrams for relay adder modules RM-312 and RM-306.
Diagram for connecting the FA-300 to a 3G4010 interface device in Canada.
Diagram for connecting the FA-300 to a 3G4010CF interface device outside Canada.
Wiring details for the PR-300 module, including protectors and ground connections.
Illustrates how to connect the power supply and batteries to the system.
Essential checks and steps to perform before powering the system.
Step-by-step guide for powering up the fire alarm control panel.
Lists common system symptoms and their possible causes.
Describes common buttons for system operation and control.
Instructions on how to access the panel's configuration mode.
Overview of the command menu structure and navigation.
Details the FA-300 configuration menu options.
Configure correlations between initiating and indicating circuits.
Enable or disable retard operation for waterflow and sprinkler circuits.
Configure the Aux Disconnect button's effect on alarm and programmed relays.
Set a timer to inhibit the Signal Silence button functionality.
Configure how the Aux Disconnect button affects Alarm and Supervisory relays.
Set the time period for automatic silencing of indicating circuits.
Program the process type for initiating circuits.
Configure zones for System Sensor's i3 devices.
Program the process type for indicating circuits.
Correlate initiating circuits to indicating circuits.
Assign labels to initiating zones.
Assign labels to indicating zones (NAC circuits).
Load the panel's default configuration settings.
View configuration type, job name, technician ID, and date/time.
Set the panel's time, date, and daylight saving options.
Instructions for changing the system's passcode.
Procedure to initiate and perform a system walk test.
Perform maintenance tests on i3 devices within a zone.
Configuration menu for the system's dialer functions.
Perform manual tests on line 1, line 2, and reset the dialer.
To Next Page
