Programming
6
Programming
Adding New Records
To add a new record, you must be in Programming Mode. Refer to Entering Programming Mode
on page 2 for instructions.
Step 1: Enter Add New Record mode
Press to add a new record. The display enters Add
New Record mode.
Step 2: Enter Dial Code
1. Enter the resident’s dial (door) code. The code may
be between 1 to 4 digits long.
2. Press to save and continue.
Step 3: Enter Relay Code
1. Enter the relay code.
2. Press to save and continue.
Step 4: Enter NSL-ID
1. Enter the NSL-ID.
2. Press to save and continue.
Step 5: Enter Elevator Code
• If elevator control is not being used, press to
save and continue.
• If elevator control is being used, please contact your
technician for assistance.
Step 6: Enter Elevator ID
• If elevator ID is not being used, press to save
and continue.
• If elevator ID is being used, please contact your
technician for assistance.
>Add New Record
Edit Record
0
Enter Dial Code
[ _ _ _ _ ]
Enter Relay Code
[ _ _ _ _ ]
Enter NSL-ID
[ _ _ ]
Enter Elevator Code
[ _ _ ]
Enter Elevator ID
[ _ _ ]
To Next Page
Loading...
Need help?
General