Programming
8
Editing Records
To edit a record, you must be in Programming Mode. Refer to Entering Programming Mode on
page 2 for instructions
Step 1: Enter Edit Record mode
1. Press (scroll up) or (scroll down).
2. Press when the arrow is pointed beside “Edit
Record”. The display enters Edit Record mode.
Step 2: Select record
1. Press (scroll up) or (scroll down) to find the
record you want to change.
2. Press when the arrow is beside the record you
want to change. The display now enters the record.
Note: Records are listed according to resident dial
code.
Step 3: Enter Dial Code
• If you want to change the dial code, enter a code
that is between 1 to 4 digits long. Press to save
and continue.
• If you do not want to change the dial code,
press to continue.
Step 4: Enter Relay Code
1. Enter the relay code.
2. Press to save and continue.
Step 5: Enter NSL-ID
1. Enter the NSL-ID.
2. Press to save and continue.
Step 6: Enter Elevator Code
• If elevator control is not being used, press to
continue.
• If elevator control is being used, please contact your
technician for assistance.
Add New Record
>Edit Record
0
1000>
1001
Enter Dial Code
[ _ _ _ _ ]
Enter Relay Code
[ _ _ _ _ ]
Enter NSL-ID
[ _ _ ]
Enter Elevator Code
[ _ _ ]
To Next Page
Loading...
Need help?
General