TAS-2000 NSL System User’s Guide
19
Editing Records
To edit a record, you must be in Programming Mode. Refer to Entering Programming Mode on
page 2 for instructions.
Step 1: Enter Edit Record mode
1. Press (scroll up) or (scroll down).
2. Press when the arrow is pointed beside “Edit
Record”. The display enters Edit Record mode.
Step 2: Select Record
1. Press (scroll up) or (scroll down) to find the
record you want to change.
2. Press to enter the record.
Step 3: Enter resident’s name
• If you want to change the resident’s name, enter it
now. (see page 16 for instructions). The name may
be up to 15 characters long. Press to save and
continue.
• If you do not want to change the resident’s name,
press to continue.
Step 4: Enter Dial Code
• If you want to change the dial code, enter a code
that is between 1 to 4 digits long. Press to save
and continue.
• If you do not want to change the dial code,
press to continue.
Step 5: Enter Relay Code
1. Enter the relay code.
2. Press to save and continue.
Step 6: Enter NSL-ID
1. Enter the NSL-ID.
2. Press to save and continue.
Add New Record
>Edit Record
0
1000 >John Doe
1001 Sam Spade
Enter Name
[ _ _ _ _ _ _ _ _ _ ]
Enter Dial Code
[ _ _ _ _ ]
Enter Relay Code
[ _ _ _ _ ]
Enter NSL-ID
[ _ _ ]
To Next Page
Loading...