What to do if the MIRKA DEOS 353CV stopped and the LED is red?
If your MIRKA Sander has stopped and the LED (right) is red, it means the tool has entered safety mode because of high temperature. Allow the tool to cool down before resuming use.
What to do if MIRKA Sander LED is red and RPM is reduced?
If the MIRKA Sander LED (right) is red and the RPM is slightly reduced, it means there's too heavy a short-term load. Use a lighter load, and the LED (right) will automatically change to green.
How to fix no light from MIRKA DEOS 353CV LED when switched on?
If there is no light from the LED (right) when your MIRKA Sander is switched on, the power cord may not be properly attached to the sander or the mains socket. Ensure that the cord is correctly connected.
General| Type | Random orbital sander |
|---|---|
| Power | 350 W |
| Power input | 350 W |
| Voltage | 230 V |
| Orbit Diameter | 3 mm |
| Orbit | 3 mm |
| Size of pad | 125 mm |
| Pad diameter | 125 mm |
| Dust Extraction | Yes |
| Packaging | Cardboard box |
| Mains cable | Yes |
| Frequency | 50/60 Hz |
| Dust system | Built-in dust extraction |
To Next Page
