27
Boot Up Floppy Seek
This item sets if the system will verify the floppy disk drive type during POST.
Boot Up Numlock Status
This item sets if the Num Lock key will be automatically activated after system
startup.
Gate A20 Option
This item uses the fast gate A20 line to access any memory above 1MB. Setting
this item to make the access faster than the normal method.
Typematic Rate Setting
This item sets if the typematic rate is to be used. When disabled, continually
holding down a key on your keyboard will generate only one instance. In other
words, the BIOS will only report that the key is down. When the typematic rate is
enabled, the BIOS will report as before, but it will then wait a moment, and, if the
key is still down, it will begin the report that the key has been depressed
repeatedly. For example, you would use such a feature to accelerate cursor
movements with the arrow keys.
When this item is set to Enabled, the following two sub-items appear.
Typematic Rate (Chars/Sec)
This item sets the rate (in characters/second) at which the keys are accelerated.
Typematic Delay (Msec)
This item sets the delay (in msecond) between when the key was first depressed
and when the acceleration begins.
Security Option
This item allows you to limit the access to the system and SETUP, or just to
SETUP.
NOTE: Security takes effect only if a password is set. (See “Set
Supervisor/User Password” in this chapter.)
To Next Page
Loading...
