Mitel 112 Installation Guide

Mitel 112 DECT Installation Guide
Ver: 3.1
1
Overview
In preparation to install the Mitel 112 DECT phone, you will the following information provided to
you by your Project Manager:
 The extension number. This extension must be pre-built in the system with a 112 Dect
Service Plan (aka Bundle).
 The SIP username.
 The SIP password.
 Private IP address for the UCCV controller
 Private IP address for UCCV datacenter server (a.k.a MSL). This IP is one host
assignment in front of the UCCV controller.
The welcome email provides all of the needed information with the exception of the private IP
address of the controller for the base station to sync with (See figure 1). The IP will be in a
format of: 10.25.2xx.xxx.
Fig 1
The installation and configuration process works as follows:
1. Prepare the voice VLAN network.
2. Connect a laptop into the voice VLAN
3. Assemble and install the base station
4. Pair the DECT phone to the base station
5. Configure the base stations server to sync with the UCCV controller and to the DECT
phone.
Service Notes:
The base station can be synced to the teleworker gateway using an over-the-top (OTT) internet
connection. However to do so, the UCCV service will require a teleworker license be purchased.
For a complete set of Mitel guides, please access Mitel Online for the documents
 Mitel FRP 12 System Guide
 Mitel 112 Handset_User_Guide_R1.0
 Mitel 112 DECT Install Guide

Mitel 112 Specifications

General

Protocols	SIP
Lines	2
Headset Port	Yes
Volume Controls	Yes
Speakerphone	Yes
Wall Mountable	Yes
Ethernet Ports	2 x 10/100 Mbps
Power	PoE