Mitel 5320 - Initial Setup for Phone Service; Activating Phones; 5304 And 5212;5312 Phones

Mitel IP Phone Reference Guide
Using Phones 31
Initial Setup for Phone Service
To set up your new phone service, follow these steps:
1. Activate your phone. See Activating Phones.
2. Perform a Quick Set-up. See Quick Set-up
Activating Phones
5304 and 5212/5312 Phones
To activate a phone you need
• an extension
• a phone,
• a PIN.
The administrator can provide you with an extension and an initial PIN.
To activate your phone, follow these steps:
1. Disconnect your computer from the network.
2. Plug the phone into the network.
3. Plug the computer into the phone at the port marked PC.
4. Connect one end of the phone power pack into your phone and the other end into a
power outlet.
If your network is configured with Power Over Ethernet (POE), the above step is not
necessary.
5. Wait for the Information Display Area to show "Logged Out" (this may take 30
seconds or more):
6. Enter *00.
The Information Display Area prompts you for your Extension:
7. Enter your extension.
8. The Information Display Area prompts you for your PIN:
9. Enter your PIN, followed by the Pound key [#].
The phone displays your extension.
You have now successfully activated the phone, and can make calls.