Mitsubishi Electric A800 Programming Manual

126
Sequence program
Sequence instructions
3.25.4 Output instruction: bit device, timer, counter ...
OUT
Function
• Operation results up to the OUT instruction are output to the specified device.
NOTE
• The OUT instruction repuires 3 steps when a special relay (M) is used.
Applicable device
Digit
specification
Error flag
Bit device
Word (16-bit)
device
Constant Level
X Y M T C D K H N (SM0)
Bit device 
Timer
Device 
Setting
value

Counter
Device 
Setting
value

OUT (Y, M)
Operation result
OUT instruction
Coil
Contact
NO contact NC contact
OFF OFF Non-conduction Conduction
ON ON Conduction Non-conduction
T0
T0
C0
C1
OUT
Y15
Device number
K50
Device number (T0 to 15)
D10
K50
Device number (C0 to 15)
OUT
OUT
Device number (T0 to 15)
Device number (C0 to 15)
(Y, M)
(T)
(C)
D10
Setting
Any of data register
contents 1 to 32767
is valid
Setting
Any of 1 to 32767 is
valid
Setting
Any of 1 to 32767 is
valid
Setting
Any of data register
contents 1 to 32767
is valid

Mitsubishi Electric A800 Specifications

General

Series	A800
Type	Inverter
Overload Capacity	150% for 60 seconds
Operating Temperature	-10°C to +50°C
Output Voltage	0-Input Voltage
Power Rating	0.4 kW to 560 kW
Control Method	V/f control, vector control
Braking Unit	Optional
Communication Protocols	Modbus, CC-Link, Profibus
Protection Features	Overcurrent, Overvoltage, Undervoltage, Ground fault
Storage Temperature	-20°C to +60°C
Humidity	95% RH or less (non-condensing)
Input Voltage	3-phase 200V to 240V, 380V to 480V
Output Frequency	0.1-400 Hz
Frequency Range	0.1-400 Hz