Mitsubishi Electric MELDAS MDS-R-V2-2020 - Initial Drive Unit Settings

8 - 1
8. Setup
8-1 Servo drive unit initial settings..................................................................................................... 8-2
8-1-1 Setting the rotary switch...................................................................................................... 8-2
8-1-2 Transition of LED display after power is turned ON............................................................ 8-3
8-2 Setting the initial parameters....................................................................................................... 8-4
8-2-1 Setting the standard parameters......................................................................................... 8-4
8-2-2 Limitations to electronic gear setting value ......................................................................... 8-8
8-2-3 Standard parameter list according to servomotor ............................................................... 8-9
8-3 List of parameters...................................................................................................................... 8-11