Mitsubishi Electric MELDAS MDS-R-V2-2020 - Page 219

Appendix 1. Cable and Connector Specifications
A1 - 21
(3) Inserting parts
Insert the clamp nut, cable clamp, bushing and angle back shell in to the cable.
(Note) Take care not to insert them upside down
Cable clamp CableBushing
A
ngle back shell
Clamp nut
* Bend and insert the cable into angle back shell.
Cable
Insert
A
ngle back shell
Bend
(4) Stripping a cable
Strip the core wire to a length 6mm.
Cable
6
Core
wire