Mitsubishi Electric MELSEC FX Series - Page 364

7 Applied Instructions
7.7 Handy Instruction
362
FXCPU Structured Programming Manual
(Basic & Applied Instruction)
1) Reshuffling results when command is executed in n=K2 (row number 2)
2) Reshuffling results when command is executed in n=K3 (row number 3)
Related devices
→ As for the method of using the command execution complete flag, see paragraph 1.3.4.
Cautions
1) Do not change the content of operand or data during operation.
2) When resuming the execution, once turn OFF the command input.
3) Limit of number of times of use of command
Usable only once in the program.
4) When designating same device in and
The original data is rewritten in the data sequence after reshuffling.
In particular, never change the content of the device designated in until the completion of execution.
5) FX
U PLC supports the command by V3.07 or higher.
6) Object devices are limited.
S1: FX
3U, FX3UC PLCs only are applicable.
Row
number
1 2 3 4
Column
number
Management
number
Height Weight Age
1
+5 +10 +15
4 100 20 8
2
+1 +6 +11 +16
1 150 45 20
3
+2 +7 +12 +17
5 150 50 45
4
+3 +8 +13 +18
3 160 70 30
5
+4 +9 +14 +19
2 180 50 40
Row
number
1 2 3 4
Column
number
Management
number
Height Weight Age
1
+5 +10 +15
4 100 20 8
2
+1 +6 +11 +16
1 150 45 20
3
+2 +7 +12 +17
2 180 50 40
4
+3 +8 +13 +18
5 150 50 45
5
+4 +9 +14 +19
3 160 70 30
Device Name Content
M8029
Command execution
complete
To be ON when data arraying is complete.