Mitsubishi Electric MELSEC FX Series - Page 381

7 Applied Instructions
7.8 External FX I/O Device
379
FXCPU Structured Programming Manual
(Basic & Applied Instruction)
1
Outline
2
Instruction List
3
Configuration of Instruction
4
How to Read Explanation of Instructions
5
Basic Instruction
6
Step Ladder Instructions
7
Applied Instructions
8
Interrupt Function and Pulse Catch Function
A
Relationships between devices and addresses
When using 4 digits and 1 set(n=K0 to K3)
→ As for selection of "n", see the second item below.
1) Data and strobe signal
The 4-digit numerical value of is converted from BIN to BCD, and is issued sequentially by time
division digit by digit from to +3.
The strobe signal output ( +4 to +7) is also issued sequentially by time division, and the 7-
segment display of 4 digits and 1 set is latched.
2) In , BIN data in a range of 0 to 9,999 is valid.
3) Connection example of 7-segment display unit
The following diagram show an example of FX
3U series basic unit (sync output). As for the actual wiring,
see the manual of the PLC.
When using 4 digits and 2 sets(n=K4 to K7)
→ As for selection of "n", see the item below.
1) Data and strobe signal
a) 4 digits, first set
The 4-digit numerical value of is converted from BIN to BCD, and is issued sequentially by time
division digit by digit from to +3.
The strobe signal output ( +4 to +7} is also issued sequentially by time division, and the 7-
segment display of 4 digits and 1 set is latched.
b) 4 digits, second set
The 4-digit numerical value of +1 is converted from BIN to BCD, and is issued sequentially by
time division digit by digit from +10 to +13.
The strobe signal output ( +4 to +7) is also issued sequentially by time division, and the 7-
segment display of 4 digits and 2 sets is latched. (The strobe signal output ( +4 to +7) is
common in each set.)
2) In and +1, BIN data in a range of 0 to 9,999 is valid.
10
0
4
2
81
1
2
4
8
First set
V+
10
1
10
2
10
3
10
3
10
2
10
1
10
0
+3
PLC (transistor output)
d
+2
d
+1
dd
COM
+6
d
+5
d
+4
d
+7
d