Mitsubishi Electric MELSEC iQ-F FX5 - Page 20

18
3 ANALOG OUTPUT MODULE FB
3.3 M+FX5-4DA_WaveOutputSetting
Error code
Timing chart of I/O signals [For normal completion]
[For error completion]
Restrictions or precautions • This FB does not include the error recovery processing. Program the error recovery processing separately in accordance
with the required system operation.
• This FB cannot be used in an interrupt program.
• Using the FB in a program that is to be executed only once, such as a subroutine program or a FOR-NEXT loop, has a
problem that i_bEN (execution command) can no longer be turned off and normal operation is not possible; Always use the
FB in a program that is capable of turning off the execution command.
• To use more than one of this FB, care must be taken to avoid duplication of the target channel.
• The FB requires the configuration of the ladder for every input label.
• When operating the analog output module, the output range setting needs to be set according to the device and system to
be connected. Set the GX Works3 module parameters according to the application. Refer to the MELSEC iQ-F FX5
User's Manual (Analog Control - Intelligent function module) for details on setting the module parameters.
Error code
(hexadecimal)
Description Action
100 The target channel is set out of the range.
Set the target channel within the following range.
• FX5-4DA: 1 to 4, 15
Review and correct the settings and then execute the FB
again.
102 The module type is set out of the range.
Set the module type to the following values.
•FX5-4DA: 0
Review and correct the settings and then execute the FB
again.
Item Description
Each setting value write processing
o_bErr
o_uErrId
0
Write Unexecuted UnexecutedUnexecuted
i_bEN
o_bENO
o_bOK
Each setting value write processing
o_bErr
o_uErrId
Unexecuted
Error code00
i_bEN
o_bENO
o_bOK