Mitsubishi Electric MELSEC iQ-F Series

To Next Page

To Previous Page

2 HIGH-SPEED COUNTER MODULE FB

2.5 M+FX5-2HC_ErrorOperation (Error Operation)

FB details

Available device

Basic specifications

Processing

• By turning on i_bEN (Execution command), error monitoring of the target channel is executed.

• o_bMonitorOK (Monitoring status) turns on when the target channel is being monitored.

• If an error occurs, o_bUnitError (Module error detection) turns on, and the error code is stored in o_uUnitErrCode (Module

error code).

• After i_bEN (Execution command) turns on, i_bErrorReset (Error reset command) is turned on while the error is occurring,

and error reset is executed.

• After error reset is completed, o_bOK (Normal completion) turns on.

Target module Firmware Version Engineering tool

FX5UJ CPU module 1.060 or later GX Works3 Version 1.100E or later

FX5U CPU module 1.300 or later GX Works3 Version 1.100E or later

FX5UC CPU module 1.300 or later GX Works3 Version 1.100E or later

High-speed counter module 1.000 or later GX Works3 Version 1.100E or later

Item Description

Language Ladder diagram

Number of steps 305 steps

The number of steps of the FB embedded in a program depends on the CPU module used, the input/output definitions,

and the options setting of GX Works3. For the option settings of GX Works3, refer to the following.

GX Works3 Operating Manual

The amount of label usage • Label: 336 points (Word)

• Latch label: 0 points (Word)

The amount of labels used in the program varies depending on the CPU module used, the device specified in an

argument, and the option setting of GX Works3. For the option settings of GX Works3, refer to the following.

Mitsubishi Electric MELSEC iQ-F Series - FB Details