Mitsubishi Electric MELSEC iQ-F Series - Chapter 4 Application Example; Error Monitoring and Count Enable Operation; Overview

4 APPLICATION EXAMPLE
4.1 Error Monitoring and Count Enable Operation
39
4
4 APPLICATION EXAMPLE
4.1 Error Monitoring and Count Enable Operation
This section describes the procedure for executing the count enable operation while monitoring for errors.
The following FBs are used in this usage example.
• M+FX5-2HC_CountEnable (Count enable operation)
• M+FX5-2HC_ErrorOperation (Error operation)
Overview
Perform count enable operation while monitoring for module errors.
System configuration
For the system configuration, refer to the following.
Page 8 System Configuration
Parameter settings
For the parameter settings, refer to the following.
MELSEC iQ-F FX5 High-Speed Counter Module User's Manual